RF communication to OOPic
Archiver
Posts: 46,084
I was wondering if anyone has experience using RF to communicate between
a Stamp 2 and an OOPic processor? I am trying to send small amounts of
data from the stamp to the OOPic at 1200 baud. I can send data between two
stamp chips at 1200 baud, no problem. I can't seem to figure out how to get
the equivalent of Serin on the OOPic to read teh data stream properly.
Is there a way of formating the data sent ( wait bit) or pauses to make the
OOPic understand to incomming stream?
thanks
ERIC
by the way, great new web page, love it.
a Stamp 2 and an OOPic processor? I am trying to send small amounts of
data from the stamp to the OOPic at 1200 baud. I can send data between two
stamp chips at 1200 baud, no problem. I can't seem to figure out how to get
the equivalent of Serin on the OOPic to read teh data stream properly.
Is there a way of formating the data sent ( wait bit) or pauses to make the
OOPic understand to incomming stream?
thanks
ERIC
by the way, great new web page, love it.
Comments
a Stamp 2 and an OOPic processor? I am trying to send small amounts of
data from the stamp to the OOPic at 1200 baud. I can send data between two
stamp chips at 1200 baud, no problem. I can't seem to figure out how to get
the equivalent of Serin on the OOPic to read teh data stream properly.
Is there a way of formating the data sent ( wait bit) or pauses to make the
OOPic understand to incomming stream?
thanks
ERIC
by the way, great new web page, love it.