BS2/NX-1000 Protoboard
Archiver
Posts: 46,084
I've been prototyping a project using the NX-1000 protoboard from Parallax.
I'm to the point of moving everything over to a semi-permanent fixture. I'd
prefer not to solder yet, so I was planning on using a standard Protoboard
from Radio Shack until everything is completly finalized. Can someone tell
me where I can get a schematic/component list on how to provide power to the
BS2 using a powersupply (w/barrel plug) like the one used on the NX-1000?
Thanks again,
Matt
I'm to the point of moving everything over to a semi-permanent fixture. I'd
prefer not to solder yet, so I was planning on using a standard Protoboard
from Radio Shack until everything is completly finalized. Can someone tell
me where I can get a schematic/component list on how to provide power to the
BS2 using a powersupply (w/barrel plug) like the one used on the NX-1000?
Thanks again,
Matt
Comments
> get a schematic/component list on how to provide power to the BS2 using a
> powersupply (w/barrel plug) like the one used on the NX-1000?
The BASIC Stamp Manual would be a good place. It is a free download:
http://www.hvwtech.com/downloads.htm
...or from the Parallax website.
Mark Hillier, VE6HVW
President, HVW Technologies Inc.
Canadian Distributors of Parallax Products and other Neat Stuff
Tel: (403)-730-8603 Fax: (403)-730-8903
See our NEW FPGA Experimenter Board
http://www.hvwtech.com/intro-fpga.htm