PCB fabrication questions
Archiver
Posts: 46,084
Hi all,
My name is Randy Knutson and I am from the University of Minnesota, Mankato. I
am currently doing a research paper on printed circuit board fabrication and was
wondering if anyone out there knew the steps, machines, software packages, etc.
for making a high density circuit board. (trace widths <5 mills) Specifically, I
am interested in industry standards for software, types of masks used,
developing chemicals, etching chemicals, plating standards, solder reflow
techniques, component mounting or anything else that might be pertinent to this
report. Any and all links, information, stories etc. would be greatly
appreciated!
Thanks!
Randy Knutson
solarteam.mnsu.edu
Do You Yahoo!?
Yahoo! Games - play chess, backgammon, pool and more
[noparse][[/noparse]Non-text portions of this message have been removed]
My name is Randy Knutson and I am from the University of Minnesota, Mankato. I
am currently doing a research paper on printed circuit board fabrication and was
wondering if anyone out there knew the steps, machines, software packages, etc.
for making a high density circuit board. (trace widths <5 mills) Specifically, I
am interested in industry standards for software, types of masks used,
developing chemicals, etching chemicals, plating standards, solder reflow
techniques, component mounting or anything else that might be pertinent to this
report. Any and all links, information, stories etc. would be greatly
appreciated!
Thanks!
Randy Knutson
solarteam.mnsu.edu
Do You Yahoo!?
Yahoo! Games - play chess, backgammon, pool and more
[noparse][[/noparse]Non-text portions of this message have been removed]
Comments
Good link for that kind of info.
Al Williams
AWC
* Floating point math for the Stamp, PIC, SX, or any microcontroller
http://www.al-williams.com/awce/pak1.htm
"http://www.thinktink.com/stack/volumes/volvi/pcbproto.htm"