Problem using DS1820 and Basic Stamp 2 (2º part)
Hi,
I have some problems using Basic Stamp 2 and DS1820 digital termometer, here
I send a schematic on how I connect the BS2 and the DS1820, and the code I'm
using to read temperature frm the DS1820, I think that the problem should be
in the code, but I don't find where it's the mistake.
Please any help would be appreciated.
Regards,
Jose A.
___________
I DS1820 I + = connection
I I /// = resistor
I I
I 1 2 3 I
I I I
I I I
I +
> BS2 PIN 0
I I I
I I I
I I +
+
I I I
GND<----+ +-////
+---> +VCC
4.7K
PULLUP
_________________________________________________________________
MSN Photos es la manera m
I have some problems using Basic Stamp 2 and DS1820 digital termometer, here
I send a schematic on how I connect the BS2 and the DS1820, and the code I'm
using to read temperature frm the DS1820, I think that the problem should be
in the code, but I don't find where it's the mistake.
Please any help would be appreciated.
Regards,
Jose A.
___________
I DS1820 I + = connection
I I /// = resistor
I I
I 1 2 3 I
I I I
I I I
I +
> BS2 PIN 0
I I I
I I I
I I +
+
I I I
GND<----+ +-////
+---> +VCC
4.7K
PULLUP
_________________________________________________________________
MSN Photos es la manera m