When I last checked, the extended X-10 commands were not supported by the
BS2's built-in command constants for Xout, nor was there an Xin command.
This is not to say that this cannot be done by other methods, however. With
a little imagination and a good reliable zero-crossing detection circuit,
extended commands should be possible.
Chris
Is it possible to send/receive extended X-10 code and/or data
commands using the BS2?
Comments
BS2's built-in command constants for Xout, nor was there an Xin command.
This is not to say that this cannot be done by other methods, however. With
a little imagination and a good reliable zero-crossing detection circuit,
extended commands should be possible.
Chris
Is it possible to send/receive extended X-10 code and/or data
commands using the BS2?