Shop OBEX P1 Docs P2 Docs Learn Events
Just won''t turn (Little Step U and a Stepper Motor from Parallax) — Parallax Forums

Just won''t turn (Little Step U and a Stepper Motor from Parallax)

ArchiverArchiver Posts: 46,084
edited 2002-01-11 22:10 in General Discussion
Ok Ok, I know this shouldn't be so difficult, but my stepper motor justs
sits on the bench and buzzes. I could put a sharp edge on it and shave I
suppose.

I purchased the Little Step U and a $7.50 stepper motor (unipolar,
12volt) from Parallax and I don't know what the correct wiring is.
Parallax didn't know and the documentation that came with the Little Step
U didn't say. Yes. I know this is very odd, but it's Friday evening,
everyone is gone for the weekend and I'm dying to get this motor turning.

The unipolar motor has 5 leads.
Black (common center tap) (I checked this out with an ohm meter)
Brown
Red
Green
White

The Little Step U has the following outputs:
Center Tap (I'l put the black motor lead on this)
A
B
C
D

Leaving the Brown wire on contact A I've tried every possible combo with
the remaining 3 wires. What else am I to do? Ideas ?? An Answer
perhaps??

Chris Dundorf
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.
Sign In or Register to comment.