Using Tpin 16 for serial communication between several BS2 and PC
Archiver
Posts: 46,084
I have just started using Basic Stamp BS2.
In the Basic Stamp Manual ver. 1.9 in page 318- , there is information about
sending and receiving serial information on Tpin 0-16.
I want to set the Tpin to 16, and use the dedicated serial output, normally used
by the Stamp2 host program, to communicate between several Stamps as well as a
PC.
In this way I hope to save the rest of I/O- port fore other use.
All stamps and PC must be able to communicate to one another, without use of a
master Stamp to control the communication.
I have been searching threw all discussion mails in hope of finding something
similar done before.
Does anybody have some information about this issue then please respond by
making a little drawing of the circuitry, or maybe some BS2 codes and send it
to: Stein_Frostad@m...
--
Click here for your very own create-a-date adventure from MatchMaker
Go to http://ecard.matchmaker.com/dating.html
In the Basic Stamp Manual ver. 1.9 in page 318- , there is information about
sending and receiving serial information on Tpin 0-16.
I want to set the Tpin to 16, and use the dedicated serial output, normally used
by the Stamp2 host program, to communicate between several Stamps as well as a
PC.
In this way I hope to save the rest of I/O- port fore other use.
All stamps and PC must be able to communicate to one another, without use of a
master Stamp to control the communication.
I have been searching threw all discussion mails in hope of finding something
similar done before.
Does anybody have some information about this issue then please respond by
making a little drawing of the circuitry, or maybe some BS2 codes and send it
to: Stein_Frostad@m...
--
Click here for your very own create-a-date adventure from MatchMaker
Go to http://ecard.matchmaker.com/dating.html