Programming Error
Archiver
Posts: 46,084
Original Message
From: Tim Stockman, STOCKMAN ELECTRONICS
To: basicstamps@yahoogroups.com
Sent: Wednesday, July 25, 2001 8:37 AM
Subject: Programming Error
Stampers,
Just trying to program my first BS2e.
It tokenizes OK, but gives me a "hardware communication" error when it gets
to the download part.
What could be wrong?
Current setup:-
- Genuine BS2 serial cable being used
- Stamp powered by regulated 5v supply
- Cap in ATN line
- Compaq Contura 410 Notebook (programs other serial devices no probs!)
Stocky
[noparse][[/noparse]Non-text portions of this message have been removed]
Comments
<stocky@c...> wrote:
>
>
Original Message
> From: Tim Stockman, STOCKMAN ELECTRONICS
> To: basicstamps@y...
> Sent: Wednesday, July 25, 2001 8:37 AM
> Subject: Programming Error
>
>
> Stampers,
>
> Just trying to program my first BS2e.
>
> It tokenizes OK, but gives me a "hardware communication" error
when it gets to the download part.
> What could be wrong?
>
> Current setup:-
> - Genuine BS2 serial cable being used
> - Stamp powered by regulated 5v supply
> - Cap in ATN line
> - Compaq Contura 410 Notebook (programs other serial devices no
probs!)
>
>
> Stocky
>
>
> [noparse][[/noparse]Non-text portions of this message have been removed]
______________________________________________________________________
Stocky,
Do you have a palm pilot with hotsync loaded on your computer?
If so it can cause these sorts of errors and make the stamp software
think it can't get to the stamp.
If you do have palm pilot or hotsync e-mail me asap at
mhr_54@h...
Sincerely,
mhr_54