Lookup table logic
I have an BS2 application that takes two serial numbers (start bit, A,
pause 250ms,B), multiplies them and that number (X (where max X<250)) is
then referenced to a lookup table. This looked up number is then put out a
different line in pulse format (if the table is two digits) as Start bit,
1st digit, 10ms pause, 2nd digit... (Note digits are </= 10)
I am far too rusty for this sort of thing and would appreciate any
suggestions.
Thanks.
John :-#)#
pause 250ms,B), multiplies them and that number (X (where max X<250)) is
then referenced to a lookup table. This looked up number is then put out a
different line in pulse format (if the table is two digits) as Start bit,
1st digit, 10ms pause, 2nd digit... (Note digits are </= 10)
I am far too rusty for this sort of thing and would appreciate any
suggestions.
Thanks.
John :-#)#