Shop OBEX P1 Docs P2 Docs Learn Events
medical device application — Parallax Forums

medical device application

ArchiverArchiver Posts: 46,084
edited 2001-07-18 01:02 in General Discussion
On the parallaxinc.com web site there is mention of a medical device
application (a sip and puff) using a stamp 2 chip and designed by Steve
Cunningham of the Vancouver Robotics Club. I am very interested in
getting more information about this design, but so far all emails have
lead to dead ends. Can any one get me more information on this design.
Such help would be greatly appreciated.
Ken Burr
kennburr@i...

Comments

  • ArchiverArchiver Posts: 46,084
    edited 2001-07-18 01:02
    At 7/17/2001 Tuesday 05:31 PM, kenn burr promulgated:
    >On the parallaxinc.com web site there is mention of a medical device
    >application (a sip and puff) using a stamp 2 chip and designed by Steve
    >Cunningham of the Vancouver Robotics Club. I am very interested in
    >getting more information about this design, but so far all emails have
    >lead to dead ends. Can any one get me more information on this design.
    >Such help would be greatly appreciated.
    >Ken Burr
    >kennburr@i...
    >
    >Hi Ken -

    If all else fails, you might try reaching him through the Vancouver
    Robotics Club
    web site. You can find it here: http://sites.netscape.net/roboticsclub

    Hope that helps

    Regards,

    Bruce Bates
Sign In or Register to comment.