LM628/LM629 motion control

Archiver

Does anyone have experience using a BS2 as a host for the National Semiconductor
LM628/LM629 Precision Motion Controller? I am searching for both hardware and
software help.

(I have tried the Motor Mind B with some success, however, this device has too
many inaccuracies for my needs)

Thanks and best regards,
G.

Archiver

I recently built a whole circuit board with some I/O using the LM628. You
can not use the stamp processor with the motion controller because there is
not enough variable space. I used the BasicX processor with the ones that I
built...The circuit consist of 1-LM628, 1-Basicx 24 processor...they control
another circuit that converts the digital output to analog, which controls a
KBMM DC motor controller. I can control any DC motor up to 130 VDC with
encoder feedback.

---

Original Message

---

From: <sabolgw@u...>
To: <basicstamps@yahoogroups.com>
Sent: Friday, March 09, 2001 8:59 AM
Subject: [noparse][[/noparse]basicstamps] LM628/LM629 motion control


> Does anyone have experience using a BS2 as a host for the National
Semiconductor LM628/LM629 Precision Motion Controller? I am searching for
both hardware and software help.
>
> (I have tried the Motor Mind B with some success, however, this device has
too many inaccuracies for my needs)
>
> Thanks and best regards,
> G.
>
>
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>