basic stamp II detected but not responding ... check power supplie
i am working on Windows Me. and Stampw_v1_096 for stamp editor .
i have used mainly com1 for communication with the stamp, with no mouse
installed ( because i have only on com port ) but i have also tried this on
com 4 with mouse installed .
so except for all this things to do,there is no other way to find out
whether my stamp is burned out( destroyed) ,is there ?
cohen c4-net [noparse][[/noparse]www.011301.com]
i have used mainly com1 for communication with the stamp, with no mouse
installed ( because i have only on com port ) but i have also tried this on
com 4 with mouse installed .
so except for all this things to do,there is no other way to find out
whether my stamp is burned out( destroyed) ,is there ?
cohen c4-net [noparse][[/noparse]www.011301.com]
Comments
>i am working on Windows Me. and Stampw_v1_096 for stamp editor .
>i have used mainly com1 for communication with the stamp, with no mouse
>installed ( because i have only on com port ) but i have also tried this on
>com 4 with mouse installed .
>
>
>
>so except for all this things to do,there is no other way to find out
>whether my stamp is burned out( destroyed) ,is there ?
Elias -
>As far as I'm aware, not until you can successfully "talk" to it.
>One more thought - Make sure you have either used a source code
>filetype of .BS2 with the Windows Editor, or
> 1) have provided the proper preferences settings,
> 2) Use the '{ $STAMP BS2 ] directive as outlined in the manual.
Regards,
Bruce Bates