BS1-IC boundary=

Archiver

Component side faces battery contacts. If you haven't found it yet,

http://www.parallaxinc.com/downloads/Documentation/Basic%20Stamps/BASI
C%20Stamp%20Manual%20v2.0.pdf

will answer most of your questions.

Steve

On 9 Jan 01 at 9:14, Donald Sprotbery wrote:

> Hi guys, I have a BS1-IC and the BS1-CB carrier board purchased from
> Mouser Electronics. No info came with it. My question, which way is
> the SIP 14 module plugged in? With the components facing the
> prototype area or the battery contacts? So simple but I could not
> find this info on the Parrallax site. Thanks for any help.
>

Archiver

Thanks Steve, it was a dumb question but I didn't want to blow the chip.

---

Original Message

---

From: "S Parkis" <parkiss@e...>
To: "Donald Sprotbery" <SprotDon@w...>;
<basicstamps@egroups.com>
Sent: Monday, January 08, 2001 5:41 PM
Subject: Re: [noparse][[/noparse]basicstamps] BS1-IC boundary="----=_NextPart_000_0023_01C07


> Component side faces battery contacts. If you haven't found it yet,
>
> http://www.parallaxinc.com/downloads/Documentation/Basic%20Stamps/BASI
> C%20Stamp%20Manual%20v2.0.pdf
>
> will answer most of your questions.
>
> Steve
>
> On 9 Jan 01 at 9:14, Donald Sprotbery wrote:
>
> > Hi guys, I have a BS1-IC and the BS1-CB carrier board purchased from
> > Mouser Electronics. No info came with it. My question, which way is
> > the SIP 14 module plugged in? With the components facing the
> > prototype area or the battery contacts? So simple but I could not
> > find this info on the Parrallax site. Thanks for any help.
> >
>
>
>