Basic Stamp Manual 2.0
Archiver
Posts: 46,084
Many thanks to PARALLAX for the new Basic Stamp Manual version 2.0!
Just a couple of typo's that I've noticed at first glance: In figures
5.6 and 5.9 on pages 138 and 144 respectively(printed page numbers)
regarding the I2C commands - the values for the pull-up resistors don't
agree in the schematics vs the text description shown next to them. The
schematic in each case shows 4.7K resistors and the text in each case
describes 10K resistors being used. I'm guessing that either will work for
a pull-up, but what is most correct? Thought we all should know.
Thanks,
Tim
Just a couple of typo's that I've noticed at first glance: In figures
5.6 and 5.9 on pages 138 and 144 respectively(printed page numbers)
regarding the I2C commands - the values for the pull-up resistors don't
agree in the schematics vs the text description shown next to them. The
schematic in each case shows 4.7K resistors and the text in each case
describes 10K resistors being used. I'm guessing that either will work for
a pull-up, but what is most correct? Thought we all should know.
Thanks,
Tim
Comments
writes:
5.6 and 5.9 on pages 138 and 144 respectively(printed page numbers)
regarding the I2C commands - the values for the pull-up resistors don't
agree in the schematics vs the text description shown next to them. ·The
schematic in each case shows 4.7K resistors and the text in each case
describes 10K resistors being used. ·I'm guessing that either will work for
a pull-up, but what is most correct? ·Thought we all should know.
Use 4.7K.[/font]
Tim
Original Message
From: jonwms@aol.com <jonwms@aol.com>
To: basicstamps@egroups.com <basicstamps@egroups.com>
Date: Monday, December 18, 2000 3:56 AM
Subject: Re: [noparse][[/noparse]basicstamps] Basic Stamp Manual 2.0
[font=arial,helvetica]In a message dated 12/17/00 10:35:04 PM Central Standard Time, dema@tgi.net
writes:
5.6 and 5.9 on pages 138 and 144 respectively(printed page numbers)
regarding the I2C commands - the values for the pull-up resistors don't
agree in the schematics vs the text description shown next to them. ·The
schematic in each case shows 4.7K resistors and the text in each case
describes 10K resistors being used. ·I'm guessing that either will work for
a pull-up, but what is most correct? ·Thought we all should know.
Use 4.7K. [/font]