vector display - how do I get from here to there?
Archiver
Posts: 46,084
Hello,
I would like to use a stamp to drive 2 coils that in turn would drive two
mirrors in the X-Y planes, in order to bounce a laser off of them. creating
a vector display.
My question is:
has anyone had experience converting CAD drawings to a form that the stamp
could use do drive these actuators? What are the steps one takes to get from
a CAD drawing to a driven actuator?
I have a feeling that this is a VERY similar function to driving the X-Y
tables on a mill, just faster.
Any Ideas, or hints as to where to look out there?
regards, Ed
I would like to use a stamp to drive 2 coils that in turn would drive two
mirrors in the X-Y planes, in order to bounce a laser off of them. creating
a vector display.
My question is:
has anyone had experience converting CAD drawings to a form that the stamp
could use do drive these actuators? What are the steps one takes to get from
a CAD drawing to a driven actuator?
I have a feeling that this is a VERY similar function to driving the X-Y
tables on a mill, just faster.
Any Ideas, or hints as to where to look out there?
regards, Ed