BSAVE for BS2

Archiver

Hi everybody.

I'd like to be able to program my bs2 from a visual basic
application. The best way to do this would to use the bsave function
to send the data serially to the stamp as per the stamp manual.

Unfortunately the bsave command does not appear to be supported by
the bs2. Does anyone have any ideas how I could do this? I know that
I could use the Starche unit, but I was after something cheaper that
I could make myself.

Any ideas would be appreciated.

Thanks

Simon

Archiver

For the time been, there no support of bsave for bs2 or bs2sx.
I had an e-mail from parallax technical support that they will
support it at the next version of the editor.
It will be out toward the end of the year.

I am waiting for that me too.

Aggelos Mallios

National Centre for Marine Research
http://www.poseidon.ncmr.gr
mail: amallios@p...

Archiver

I'll believe it when I see it. I, and a lot of others, asked for this over
5 years ago. They always said it was always going to be in the next
release. I'm still waiting, but have moved on to other solutions.
M

---

Original Message

---

> Date: Thu, 9 Nov 2000 11:47:20 +0200
> From: "Aggelos Mallios" <amallios@p...>
> Subject: RE: BSAVE for BS2
>
> For the time been, there no support of bsave for bs2 or bs2sx.
> I had an e-mail from parallax technical support that they will
> support it at the next version of the editor.
> It will be out toward the end of the year.
>
> I am waiting for that me too.
>
> Aggelos Mallios
>
> National Centre for Marine Research
> http://www.poseidon.ncmr.gr
> mail: amallios@p...