Mounting a Stamp OEM Board
Archiver
Posts: 46,084
Any ideas for mounting the Stamp OEM board? It is a 2" square that
is packed with components and no predrilled holes for posts. I could
plug the SIP header into another board, but need to have the board
lay flat. This is for a robot I am building. Was thinking about
using the clips that are used for holding the screen on a screen door
in place, but there has to be a better way. Any ideas?
is packed with components and no predrilled holes for posts. I could
plug the SIP header into another board, but need to have the board
lay flat. This is for a robot I am building. Was thinking about
using the clips that are used for holding the screen on a screen door
in place, but there has to be a better way. Any ideas?
Comments
>Any ideas for mounting the Stamp OEM board? It is a 2" square that
>is packed with components and no predrilled holes for posts. I could
>plug the SIP header into another board, but need to have the board
>lay flat. This is for a robot I am building. Was thinking about
>using the clips that are used for holding the screen on a screen door
>in place, but there has to be a better way. Any ideas?
Thin strips of double-sided foam tape might work. 3-M offers it for
mounting photographs, among other things. Many stationary stores carry it.