Shop OBEX P1 Docs P2 Docs Learn Events
Newbie needs help with PULSOUT — Parallax Forums

Newbie needs help with PULSOUT

ArchiverArchiver Posts: 46,084
edited 2000-10-19 21:04 in General Discussion
Hi, I'm trying to send a pulsing signal to a pin for 100 micro-sec
with

pulsout 0,50


but pin 0 continues to receive a pulsing signal after 100
microseconds.

please advise how i can keep the signal to 100 microseconds. thanks!
supras@y...

Comments

  • ArchiverArchiver Posts: 46,084
    edited 2000-10-19 21:04
    Are you using a BS1 or BS2? The BS1 command works in 10 us units, while the
    BS2 uses 2 us units. Your command is OK for a BS2. For a BS1 you need:
    pulsout 0,10.

    Regards,
    Ray McArthur
    Original Message
    From: <sky1ar@y...>
    To: <basicstamps@egroups.com>
    Sent: Thursday, October 19, 2000 2:27 PM
    Subject: [noparse][[/noparse]basicstamps] Newbie needs help with PULSOUT


    > Hi, I'm trying to send a pulsing signal to a pin for 100 micro-sec
    > with
    >
    > pulsout 0,50
    >
    >
    > but pin 0 continues to receive a pulsing signal after 100
    > microseconds.
    >
    > please advise how i can keep the signal to 100 microseconds. thanks!
Sign In or Register to comment.