Brian''s very basic question
Archiver
Posts: 46,084
I just bought a BSIISX and Super Carrier Board. With power applied
and the serial cable connected, I tried to start the Stamp for the
first time. The error message I get is, "BASIC Stamp detected on
COM1 but not responding. Check power supply. Could not open port.
Reason is unknown." I do have the largest chip on the BSIISX
(labeled Scenix) oriented closest to the Reset button. Is this what
caused my problem? Is it dead and my 60 bucks wasted? Thank you for
any response.
and the serial cable connected, I tried to start the Stamp for the
first time. The error message I get is, "BASIC Stamp detected on
COM1 but not responding. Check power supply. Could not open port.
Reason is unknown." I do have the largest chip on the BSIISX
(labeled Scenix) oriented closest to the Reset button. Is this what
caused my problem? Is it dead and my 60 bucks wasted? Thank you for
any response.