Multitasking
Group,
Is it possible to drive a servo motor until an event (Limit switch, bar code, etc.) occurs?
my stamp is so busy accelerating, driving, and decelerating the servo via PWM that it has no time to "watch" an input pin.
Please help,
David Fixemer
Fixemerd@Navix.net
Is it possible to drive a servo motor until an event (Limit switch, bar code, etc.) occurs?
my stamp is so busy accelerating, driving, and decelerating the servo via PWM that it has no time to "watch" an input pin.
Please help,
David Fixemer
Fixemerd@Navix.net
Comments
without the Stamp's constant intervention. You set the PWM rate you want on
any channel (8 channels all at the same time are possible) and then it will
continue to run until you change or stop it.
Regards,
Al Williams
AWC
* Basic Stamp FAQ: http://www.al-williams.com/wd5gnr/stampfaq.htm
Original Message
From: Production Technology, Inc. [noparse]/noparse]mailto:[url=http://forums.parallaxinc.com/group/basicstamps/post?postID=YMx_UO8KBFaSaednLUtlR53LQ0Ct46otzoxO96lGku0I7j1WQ0sMDULvaNkSIaNA7y79Nk8qDho]FIXEMERD@N...[/url
Sent: Tuesday, August 22, 2000 10:39 AM
To: basicstamps@egroups.com
Subject: [noparse][[/noparse]basicstamps] MULTITASKING
Group,
Is it possible to drive a servo motor until an event (Limit switch, bar
code, etc.) occurs?
my stamp is so busy accelerating, driving, and decelerating the servo via
PWM that it has no time to "watch" an input pin.
Please help,
David Fixemer
Fixemerd@N...