IMU Blockly Issues

jreile

I am new to the 9 Axis IMU module. I am trying to write a simple program to return a heading value just to get started. I have already calibrated the module (I think). I am only using the module in two axes for a simple 0-359 degree reading. Every time I run this program it tells me that there is too much data being sent to the terminal. Does anyone have any ideas on what might be going on. I have attached a picture of my program and error I'm receiving.

VonSzarvas

Did you try increasing the value in the pause statement yet? Maybe from 150 up to 1000.

jreile

Yes, I did try that. Same issue.