parallax.com site down?

Phil Pilgrim (PhiPi) · 2018-04-19 19:20

Anyone else not able to connect? I emailed their webmaster, but email might not be working either.

-Phil

tomcrawford · 2018-04-19 19:25

Down from here.

yeti · 2018-04-19 19:28

No ping, traceroute fails and browsers timeout.
Tested from ".de" and Seattle.

Jen J. · 2018-04-19 19:31

Yep. They're on it. Should be up again soon.

microcontrolleruser · 2018-04-19 21:30

It's holding up my life!

At least the hobby part of it.

Went looking for handy code that is usually on product sell page.

In this case LCD.

This shoots down idea of quickly running LCD program to see what it's like.

Courtney Jacobs · 2018-04-19 22:05

Attached are the code downloads for our LCDs.

microcontrolleruser · 2018-04-20 02:02

Thank you Courtney.

Phil Pilgrim (PhiPi) · 2018-04-20 02:13

It's baaaack! Thanks, web gurus!

-Phil

RS_Jim · 2018-04-20 14:10

Right now, I seem to have the same problem with Obex.
Jim

Courtney Jacobs · 2018-04-20 14:54

Unfortunately OBEX was included in our technical issues, but first priority had to be our main site Parallax.com.

IT is working on the situation; thank you for your patience.

RS_Jim · 2018-04-20 15:11

Thanks Courtney

trooks · 2018-05-12 10:45

Strange that I can get on this forum but not in Parallax.com. My browser says the site timmed out.

It has been quite a while since I was here. I have tried way too long to do it all myself but this old dog may have learned his last new trick.

I need to find an engineer to critique(sp?) my finished circuit and generate a file that will allow for production.

I have tried to learn how to do these things but my old weak eyes and cataracts and fingers that are no longer as nimble and sure as they once were have let far too much 'magic smoke' out of some mighty fine components.

I am in a position to pay for this service and would really like to see this product in use before they throw dirt in my face.

I have married a BS2 to a Digi Xbee Pro S1 and reasonably expect our first demo tape will likely ignite a few select groups

I have gotten a lot of tips and advise from this forum and directly from Parallax over the last few years and think this is a likely place to look for help again.

Thanks Y'all for wading throughmy wordieness,

Tim

Heater. · 2018-05-12 11:26

parallax.com is down just now, at least cannot be connected to from Scandinavia.

Also this forums has been very slow loading this weekend, as I mentioned in another thread.

parallax.com site down?

Comments