XBee XB24C set as Coordinator
Breiti
Posts: 2
Hi
I am new to XBee and i can't find any answers to my questions about the XB24C that i am using anywhere on the internet (not even at digi.com).
My problem: I use two XB24C modules each on one Arduino Mega 2560 with the original Arduino Wireless & SD Shield and i want them to communicate.
I looked up how that works on the arduino.cc tutorial website and i got the tutorial for the XB24-B, but i need to know how to
Can anyone help me please? Or does anyone know where i can get a full tutorial for the XB24C?
Thxalot in advance
Breiti
I am new to XBee and i can't find any answers to my questions about the XB24C that i am using anywhere on the internet (not even at digi.com).
My problem: I use two XB24C modules each on one Arduino Mega 2560 with the original Arduino Wireless & SD Shield and i want them to communicate.
I looked up how that works on the arduino.cc tutorial website and i got the tutorial for the XB24-B, but i need to know how to
1. set one of the XB24c to Coordinator
2. pretty much everythig else that i need to know
Can anyone help me please? Or does anyone know where i can get a full tutorial for the XB24C?
Thxalot in advance
Breiti
Comments
You can directly set the DH and DL addresses which will make it to the Coordinator (hopefully?)
Please correct me if this is wrong (i will find out by myself in about 5 minutes)
Later Edit: good idea but sooo dang wrong xD
for everyone else looking for a solution:
http://www.digi.com/support/forum/55158/xbee-s2c-configure-as-coordinator-at
found that after like 3 hours of searching
I am having the same Damn problem. So I was wondering did you fix it ? Thanks