ActivityBot with RN42 Bluetooth Chip 20 pins as Xbee type
I FOLLOWED THE PROCEDURE OF KENICHI ActivityBot User guide. and apparently all is fine but the ActivityBot did not has any Movements
I Download the google play app also i Load the program with eeprom button and all is fine also i get link with my movil phone Samsung Galaxy Prime
and show me coordinates x= some value y=some valueand z=0.0 and the RN 42 Bluetooth module blinks DO led Indicator only. i connected DO to pin 10 and DI to pin 11 on ActivityBot and did not move in any direction , only the 3 green shafts of the android app are active but did not trasmit any movement of the robot.
somebody has a tip for me to comunicate by bluetooth to the ActivityBot.
Thanks
my Best Regards
Jesus perez Carreño
I Download the google play app also i Load the program with eeprom button and all is fine also i get link with my movil phone Samsung Galaxy Prime
and show me coordinates x= some value y=some valueand z=0.0 and the RN 42 Bluetooth module blinks DO led Indicator only. i connected DO to pin 10 and DI to pin 11 on ActivityBot and did not move in any direction , only the 3 green shafts of the android app are active but did not trasmit any movement of the robot.
somebody has a tip for me to comunicate by bluetooth to the ActivityBot.
Thanks
my Best Regards
Jesus perez Carreño
Comments
forums.parallax.com/discussion/161436/bt-commander-w-whiskers-android-control-for-activitybotI
I show an ActivityBot C program I wrote that combines the C Learning Tutorial on the Whiskers (navigating by touch) with an Android Bluetooth app "Bluetooth Joystick Commander". It works on android tablets. It should work with Android phones.
The link to the app is in the thread along with some photos of the electrical connections. I think I am using the same RN42 device that you are.
Hope this helps.
Tom
MY BEST REGARDS
JESUS PEREZ CARREÑO