Shop OBEX P1 Docs P2 Docs Learn Events
Is there a P1 board with radio? — Parallax Forums

Is there a P1 board with radio?

ErlendErlend Posts: 612
in Propeller 1
Ideally I would like to get a few tiny boards with P1, minimum support circuitry, and nRF24L01+ on it. Something like Propeller Mini + nRF. The application I have in mind is wireless sensors. A platform that will allow me to stay within Spin. I have trawled the forum to see if anyone have made this (for sale) but without success. Below picture is of the breadboard dev setup, also including an MCP9808 temperature sensor with I2C interface. My default plan was to put these three on a mother pcb with batt and reg. Does anyone know of a better, more compact solution?

Erlend
WiSens.jpg
807 x 1162 - 166K

Comments

  • JonnyMacJonnyMac Posts: 9,105
    Seems like an opportunity for you to produce a useful product to sell to others! :)
  • ErlendErlend Posts: 612
    JonnyMac wrote: »
    Seems like an opportunity for you to produce a useful product to sell to others! :)
    I am at constant buffer overload - so much I want to learn and do. After half a century it still shows no sign of slowing down. I did PCBs in the old ages, but now I am putting off learning to do SMD PCBs. Probably not too hard, but it is just one more 'thing' in the input buffer. I've gotten as far as to install PCB Express, and that's it.

    Erlend

  • JonnyMacJonnyMac Posts: 9,105
    edited 2016-01-03 21:02
    If you build it yourself you'll get exactly what you want!
  • Martin HodgeMartin Hodge Posts: 1,246
    edited 2016-01-03 21:16
    Erlend wrote: »
    I did PCBs in the old ages, but now I am putting off learning to do SMD PCBs.

    I was in the same boat.
    Lamented that everything was SMD.
    Then I tried it, and now I prefer working with SMD.
Sign In or Register to comment.