PropTool v1.3.2 on Windows 10 - Change the "Post Reset Delay" if it does not find your Prop Chip
Cluso99
Posts: 18,069
in Propeller 1
I normally run my prop boards using my Windows 7 Laptop.
However, I was sure I had tried my Windows 10 Laptop and it was working.
Recently I installed an SSD (Samsung 850 EVO 120GB) replacing my HDD on my Windows 10 Laptop.
I just tried my prop board on my Windows 10 laptop and it failed to recognise the prop. While I was sure I had it working before, I just cannot be certain. Was it the installation of the SSD, and how could this affect PropTool???
Anyway, I have it working now
In PropTool, go to Edit/Preferences/Operation and in the Communication section, change the "Post Reset Delay". It was set to 300ms which failed. On my laptop 60-240ms works and anything 250ms and above fails. Remember to click "Accept" after changing the value.
However, I was sure I had tried my Windows 10 Laptop and it was working.
Recently I installed an SSD (Samsung 850 EVO 120GB) replacing my HDD on my Windows 10 Laptop.
I just tried my prop board on my Windows 10 laptop and it failed to recognise the prop. While I was sure I had it working before, I just cannot be certain. Was it the installation of the SSD, and how could this affect PropTool???
Anyway, I have it working now
In PropTool, go to Edit/Preferences/Operation and in the Communication section, change the "Post Reset Delay". It was set to 300ms which failed. On my laptop 60-240ms works and anything 250ms and above fails. Remember to click "Accept" after changing the value.
Comments
What is the valid range window for the Win7 laptop ?