Brushless Outrunner motor Hooked up to Gears IDS II Speed controller

Daftjustice

Hi I'm working on a POV clock and need to hook up this 1000kv motor from parallax to a Gear IDS II speed controller my Question is where does the yellow wire on the motor hook up. I attached the PDF for the Speed controller.

Publison

The motor you describe is a Brushless motor and needs a ESC, (Electronic Speed Controller)
There are three connection to the ESC.

https://en.wikipedia.org/wiki/Electronic_speed_control

Such as:https://www.parallax.com/product/750-90009

Daftjustice

Publison wrote: »

The motor you describe is a Brushless motor and needs a ESC, (Electronic Speed Controller)
https://en.wikipedia.org/wiki/Electronic_speed_control

Such as:https://www.parallax.com/product/750-90009

Thanks I knew was over looking something.

Publison

Daftjustice wrote: »

Publison wrote: »

The motor you describe is a Brushless motor and needs a ESC, (Electronic Speed Controller)
https://en.wikipedia.org/wiki/Electronic_speed_control

Such as:https://www.parallax.com/product/750-90009

Thanks I knew was over looking something.

BTW, Welcome to the forums!