Shop OBEX P1 Docs P2 Docs Learn Events
PSCU and SimpleIDE — Parallax Forums

PSCU and SimpleIDE

ajwardajward Posts: 1,130
edited 2015-07-03 04:59 in General Discussion
After digging my two bipeds out of the bottom of the closet, I stated thinking (yes, yes, I know!). Anyhow, if I program the Prop Servo Control Unit with SimpleIDE, what would be the "proper" board type to set? I'm just guessing, but it seems maybe "Generic"?
Just another thing to go on the back burner. ;-)
Amanda

Comments

  • mindrobotsmindrobots Posts: 6,506
    Amanda, I've had the best luck with generic if the board specifically isn't listed. It's basically a 5MHz crystal and not much else. I don't think the board config files say anything about EEPROM size. QuickStart would probably work too but I'd try Generic first.
Sign In or Register to comment.