Shop OBEX P1 Docs P2 Docs Learn Events
Changes needed on Propeller Demo Board #32100 — Parallax Forums

Changes needed on Propeller Demo Board #32100

PublisonPublison Posts: 12,366
edited 2015-01-13 09:56 in General Discussion
As was pointed out in this thread:

http://forums.parallax.com/showthread.php/159643-Program-P8X32A-directly?p=1310346#post1310346

all the resistors are marked with a "W" suffix instead of an ohm symbol.

I now it's a discontinued product, but it is used in the Propeller tool as a demo schematic.

Comments

  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2015-01-12 10:01
    I have entered this into our issue tracking system internally. So it's on the TO-DO list. =)
  • PublisonPublison Posts: 12,366
    edited 2015-01-12 10:22
    Chris Savage wrote: »
    I have entered this into our issue tracking system internally. So it's on the TO-DO list. =)

    Thanks Chris,

    I would do it my self, but I lost my full Adobe install.
  • PublisonPublison Posts: 12,366
    edited 2015-01-13 08:06
    Chris,

    The 2006 schematic seems to be fine. I'm not sure what the "artifacts" means in this statement on the Product Download page.
    New version uploaded 2 November 2012 same board revision but without PDF artifacts
    pdf
    pdf
    Propeller Demo Board Rev D_E_F Schematic_OLD.pdf
    205K
  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2015-01-13 09:06
    In the transfer to the PDF format it looks like the Omega symbol was turned into a "W" somehow.
  • GordonMcCombGordonMcComb Posts: 3,366
    edited 2015-01-13 09:49
    Chris Savage wrote: »
    In the transfer to the PDF format it looks like the Omega symbol was turned into a "W" somehow.

    Common issue with font substitution. The symbol font for omega translates to a W in most Roman fonts (Arial, Times, etc.).
  • PublisonPublison Posts: 12,366
    edited 2015-01-13 09:56
    Chris Savage wrote: »
    In the transfer to the PDF format it looks like the Omega symbol was turned into a "W" somehow.

    I was just trying to understand why the the new PDF on the Product Page was introduced, when the old schematic, (which is still shipped with the new Propeller Tool), was fine.



    Just trying to help
Sign In or Register to comment.