That schematic problem seems to have been fixed. "404 Not Found"
Now having a problem posting a response. Keep getting server not found. This is try #3.
I had to reboot my laptop to continue working on my current project and wondered if powering down and rebooting would make a difference with the "Can you display this �� ?" question. Still getting the two unicode characters after powering down and rebooting. Suspect it is something on the forum server or internet causing it.
In Finland children don't need dictionaries after fourth grade or thereabouts, for spelling any known or unknown words they hear. The concept of a spelling bee doesn't exist. Try that with limiting the charset to ASCII.. and you really can't substitute those three letters for ASCII variants. Believing that is just ignorance. The Norwegian
To the original topic, one of my past clients uses one of my M44D40+ modules with a PropPlug piggybacked to it in a very small handheld enclosure to program EEPROMS. The DIP8 EEPROM socket on the M44D40+ module was replaced with a raised socket so it protrudes out the top of the box. He plugs it into a computer, plugs a DIP8 EEPROM into the socket, and programs the EEPROM with PropTool. His plan was to also add a uSD card socket and DIP switch so that multiple files could be placed on the uSD card and programmed via SD bootloader code stored on a main EEPROM. In this setup, the programmed EEPROM would be in a socket pinned as a separate address.
Comments
In Finnish they don't use C, or B or Q. So somebody has already been thinking about this redundancy problem. But then they added
The op got an answer - see post 8, and yes the thread did wander off topic, but it was the schematic from this link “http://www.parallax.com/sites/default/files/downloads/32100-Propeller-Demo-Board-Schematic-RevG_0.pdf” that sent the thread off in to the weeds. Perhaps time to fix it?
I added a "Suggestions to Parallax" post. Since the Demo Board is a discontinued product, not sure how long that would take.
That schematic problem seems to have been fixed. "404 Not Found"
http://www.parallax.com/sites/default/files/downloads/32100-Propeller-Demo-Board-Schematic-RevG_0.pdf
Now having a problem posting a response. Keep getting server not found. This is try #3.
I had to reboot my laptop to continue working on my current project and wondered if powering down and rebooting would make a difference with the "Can you display this �� ?" question. Still getting the two unicode characters after powering down and rebooting. Suspect it is something on the forum server or internet causing it.
M44D40+ Module thread link: http://forums.parallax.com/showthread.php/131867
PropPlug link: http://parallax.com/product/32201
Polycase enclosure used: http://www.polycase.com/vk-62-black
DIP socket used: Samtec ESW-104-24-G-S http://avnetexpress.avnet.com/store/em/EMController?term=ESW-104-24-G-S&action=products&N=0