Looking for custom PCB for the BS2

DavidNyman

Does anyone have experience with getting a custom PCB done for the basic stamp 2?
I purchased a custom board from ebay that's about 4" long and 1-1/2" wide. The board is a great idea but is very low quality. I'd really like through hole plating and require only single side etching.
Any suggestions would be great.
Thanks

Leon

DavidNyman wrote: »

I'd really like through hole plating and require only single side etching.

???

DavidNyman

I should have read that one a little closer. lol
I would like through hole plating. Period
4PCB.com seems to be a favorite of some folks.

Genetix

What's wrong with these?
http://www.parallax.com/product/27130
http://www.parallax.com/product/27120

Publison

ExpressPCB is a good resource for getting small PCB's made. There have many been made here on the forums. On example is the ever popular http://gadgetgangster.com/find-a-project/56?projectnum=168 designed by JonnyMac on the forums here. It is a propeller based but the software is east to use to create any board you like.

DavidNyman

Genetix wrote: »

What's wrong with these?
http://www.parallax.com/product/27130
http://www.parallax.com/product/27120

They don't fit the original size I mentioned above.

DavidNyman

Publison wrote: »

ExpressPCB is a good resource for getting small PCB's made. There have many been made here on the forums. On example is the ever popular http://gadgetgangster.com/find-a-project/56?projectnum=168 designed by JonnyMac on the forums here. It is a propeller based but the software is east to use to create any board you like.

Thank you for the tip. I'll contact them and see what they can do for me.