happy coincidence - prototype board for the BE MICRO CV
Bill Henning
Posts: 6,445
Sometimes there is a happy coincidence...
I was checking my prototyping boards to see if anything would stack on top of the BE MICRO CV.
Guess what?
My EZasPi Proto 300 works perfectly with it! I'll post some photos tomorrow, but it spans both 40 pin headers perfectly, and using female headers mounted on the bottom of the Proto 300 the BE/CV can stack below it!
If I use stacking headers, several Proto 300's could stack on top. This also solves the lack of mounting holes on the BE/CV, as my proto boards have mounting holes.
For more horizontal prototyping, the 300's (or 600's) can be used as wings for the BE/CV.
I was checking my prototyping boards to see if anything would stack on top of the BE MICRO CV.
Guess what?
My EZasPi Proto 300 works perfectly with it! I'll post some photos tomorrow, but it spans both 40 pin headers perfectly, and using female headers mounted on the bottom of the Proto 300 the BE/CV can stack below it!
If I use stacking headers, several Proto 300's could stack on top. This also solves the lack of mounting holes on the BE/CV, as my proto boards have mounting holes.
For more horizontal prototyping, the 300's (or 600's) can be used as wings for the BE/CV.
800 x 599 - 360K