Trade! I Want a USB O-Scope!

Mikerocontroller

Hi Stampers & PropHeads. I could use a PC/USB-based Oscilloscope (such as the PropScope). I would like to do a trade . I have lots of Parallax stuff. Forgive me in advance if I am in violation of any forum rules or protocol. I'll remove this post if there are any issues. I used to be active on these forums around 2008-2010. If you remember such epic Stamp "hacks" like the LCD Slot Game, Improved OLED Slots, and the Autonomous IR/Ultrasonic Servo Tank then you might recall me as Mikerocontroller (MJD 595 on YouTube).

Heres the list of available items I have ready for trade. Please see if some combination (but not ALL) will get me YOUR scope!

BS2 HomeWork Board (9V Transistor Batt., Serial), Propeller Starter Kit (complete, AC adapt, book..rev F board), Parallax RFID Reader (w/ 1 tag, 1 card), Vmusic2 MP3/USB Device, Pololu Dual Serial Motor Controller, Sound PAL, BS2 OEM module (assembled kit, 50 mHz, 64 bytes scratchpad ram), Raspberry Pi Rev. 2.0, Robotic Vehicle Chassis (dual-servo drive, tank treads...w/o sensors/micro...my avatar!)


Thanks for viewing
Mikerocontroller

Chris Savage

Mikerocontroller wrote: »

BS2 OEM module (assembled kit, 50 mHz, 64 bytes scratchpad ram)

I don't have anything to offer, save a correction...the BS2 does not have ScratchPad RAM. Didn't want to see that come back to you.

NWCCTV

Do you know the parallax item number for the Propeller Starter Kit? Also, do you know the model number for the Pololu controller? What are the dimensions of the Robot chassis?