Need coding Help for keypad and LCD sheild interface

ajit.nayak87

Dear all,

http://www.digibay.in/433-16x2-lcd-and-keypad-shield-i2c-spi-for-arduino?filter_name=LCD

http://www.digibay.in/253-4%C3%975-matrix-20-key-membrane-switch-keypad?filter_name=keypad

I am planning to use above component as interface.I need small coding help here.
I need to set perameter like below
latitude:__degree
longitude:__degree
date:dd/mm/yy
time:hh/mm/sec
start time:9
stop time:18
Enter to save data. Once data being set it has used throughout program. and provision to change the perameter.
Can some one help me in coding.

I gone through LCD and Keypad Interface . But i need some code to get started.

mklrobo

ajit.nayak87 wrote: »

Dear all,

http://www.digibay.in/433-16x2-lcd-and-keypad-shield-i2c-spi-for-arduino?filter_name=LCD

http://www.digibay.in/253-4

Franklin

ajit.nayak87 does this have anything to do with Parallax products? I'd recommend you try the Arduino forums if you are using an Arduino.

mklrobo

Franklin wrote: »

ajit.nayak87 does this have anything to do with Parallax products? I'd recommend you try the Arduino forums if you are using an Arduino.

Good point, Franklin. I probably need to look into Arduino products myself, they are looking strong. I still love Parallax, I grew up with the company.(so to speak)

JonnyMac

I probably need to look into Arduino products myself, they are looking strong.

The most popular kid on the playground is rarely the smartest....

mindrobots

JonnyMac wrote: »

The most popular kid on the playground is rarely the smartest....

Brilliant!!

Jon, is this going to be the second t-shirt in your series??

Erlend

mindrobots wrote: »

Brilliant!!

Jon, is this going to be the second t-shirt in your series??

Second that!

Erlend

mklrobo

ajit.nayak87 wrote: »

Dear all,

http://www.digibay.in/433-16x2-lcd-and-keypad-shield-i2c-spi-for-arduino?filter_name=LCD

http://www.digibay.in/253-4

JonnyMac

I written a lot of LCD code (for personal and commercial projects), and have a specific driver than includes button inputs. That driver (which is attached for reference) uses digital inputs -- so the only useful element is the raw LCD code. That shield uses the ADC to detect buttons. If you attach it to a Propeller ASC, then it will be easy to translate the Arduino demo code to the Propeller.