Shop OBEX P1 Docs P2 Docs Learn Events
I can not calibrate the ActivityBot ! HELP!! — Parallax Forums

I can not calibrate the ActivityBot ! HELP!!

JarvanJarvan Posts: 31
edited 2013-10-01 02:14 in General Discussion
I followed the tutorials carefully, but after I load the calibrate program in it, one side wheel always move and another one didn't . and the calibrate program cann't stop. Is there anyone who can help. by the way, I am Chinese, and my English is terrible, I hope you can understand my words.

Comments

  • DmashekDmashek Posts: 49
    edited 2013-10-01 00:38
    Jarvan wrote: »
    I followed the tutorials carefully, but after I load the calibrate program in it, one side wheel always move and another one didn't . and the calibrate program cann't stop. Is there anyone who can help. by the way, I am Chinese, and my English is terrible, I hope you can understand my words.

    Dude, your English skills ROCK! I could point out any number of native English speakers of all ages that you would put to shame. :)
  • ElectricAyeElectricAye Posts: 4,561
    edited 2013-10-01 02:14
    Your English skills are fine.

    As for your ActivityBot, make sure you have your electrical connections done properly. You must have the jumpers and the motor connections lined up the right way for both motors. Have a look at the following page to double check:

    http://learn.parallax.com/activitybot/electrical-connections
Sign In or Register to comment.