Basic Stamps

boyinokc

I have a question on the RF 433Mhz Transceiver

I have 3 transceiver: 1- transmitter and 2 other is receiver(1 for the light and 1 for the servo motor).

So 2 switch from transceriver circiuit. When I hit 1 switch the light is on. However when I hit the 2nd switch the motor runs for a while and then it stops and run again.

Is that possible if I run 2 receiver at the same time on 1 transmitter?

Thanks !

Mike Green

As far as the transceivers are concerned, you can have one unit in transmit mode and the other two in receive mode. The receive units should receive the same thing unless there's a lot of noise near one unit or one is much further away than the other.