Accessing I2C pins on the Eddie
radioactive28
Posts: 1
I got an Eddie a while back for a project, and have been looking to complement it with some additional sensors (accelerometer, gyro).
However, looking at the Eddie control board schematics, the I2C pins on the Propeller seem to be disabled, or at least not available via any pads.
Is there any proper way to tap those pins and/or mount additional sensors on the control board? Or do I need to get a QuickStart or bare proto board?
However, looking at the Eddie control board schematics, the I2C pins on the Propeller seem to be disabled, or at least not available via any pads.
Is there any proper way to tap those pins and/or mount additional sensors on the control board? Or do I need to get a QuickStart or bare proto board?