Shop OBEX P1 Docs P2 Docs Learn Events
Which Propeller board for moving from prototype to finished? — Parallax Forums

Which Propeller board for moving from prototype to finished?

ErlendErlend Posts: 612
edited 2013-01-21 12:20 in Propeller 1
I am still at the stage of prototyping, wiring up sensors, etc. to a Prof Dev Board through an interface board. It is my first adventure with Prop, and it is ages ago since I last made anything of this kind. Now I have started thinking about making the finished product

My question is, what board should I purchase? The project takes up 28 of the Prop I/O, and 8 channels of AI through MCP3208. I need USB, microSD, and wav playing. Would be nice to connect by means of pins & jumper wires going to my interface board.
The budget isn't too tight. Space is no problem. Power is no problem.

Erlend

Comments

  • LeonLeon Posts: 7,620
    edited 2013-01-21 03:33
    Design a PCB?
  • ErlendErlend Posts: 612
    edited 2013-01-21 04:18
    Leon wrote: »
    Design a PCB?

    Next time maybe. I've done my fair share of Ferric Chloride messing. Good idea though, I could just extend the Parallax layout with my own interface circuit. And, of course I would buy the finished PCB on the internet this time.
  • TtailspinTtailspin Posts: 1,326
    edited 2013-01-21 07:32
    The new USB Project boards sure look nice, lots of room to grow...


    -Tommy
  • kwinnkwinn Posts: 8,697
    edited 2013-01-21 10:17
    Ttailspin wrote: »
    The new USB Project boards sure look nice, lots of room to grow...


    -Tommy

    I agree. Good choice to make a finished product.
  • Prophead100Prophead100 Posts: 192
    edited 2013-01-21 12:20
    If your project is only making a limited number of boards, the USB protoboard may be all you need for a final product with power supply and usb already handled.
Sign In or Register to comment.