Shop OBEX P1 Docs P2 Docs Learn Events
Trying to add another ping sensor to the Eddie Board — Parallax Forums

Trying to add another ping sensor to the Eddie Board

jdoleckijdolecki Posts: 726
edited 2012-11-21 08:38 in Robotics
I trying to modify the Eddie Firmware so I can add another ping sensor on my robot. This one is facing backwards so my robot will not back into anything.

I have been looking at the Eddie Program and have identified all the references to Ping in it.( Sorry it doesn't copy the Line numbers)

On line 46 Pin Assignments I added PING_2 =2

On line 75 I added I< PING_2

Comments

  • jdoleckijdolecki Posts: 726
    edited 2012-11-21 08:38
    When I run the Serial Terminal and type in the Ping Command

    All 3 sensors show up but the values are in Hex?
Sign In or Register to comment.