Shop OBEX P1 Docs P2 Docs Learn Events
SPIN and MS Robotics Studio — Parallax Forums

SPIN and MS Robotics Studio

NWCCTVNWCCTV Posts: 3,629
edited 2012-09-30 09:03 in Propeller 1
So, I am just getting started with the Propeller and SPIN. I was just wondering if anyone has been able to integrate SPIN/Propeller with MS Robotics studio? If so, Where do I go to learn how to do this?

Comments

  • ericballericball Posts: 774
    edited 2012-09-29 05:29
    I'll give the same response I did in August:
    Unfortunately, there doesn't appear to be much information on the forum regarding MS Robotics Developer Studio, although Parallax does have the Eddie Robot Platform (http://www.parallax.com/eddie) which is "compatible" and appears to be Propeller based. You might want to start there if RDS is a requirement for your project.
  • StefanL38StefanL38 Posts: 2,292
    edited 2012-09-30 01:27
    what would be the advantage of MS robotic studio over propeller-tool or bst?

    I don't like MS I'm still using still windows just because linux is still too fiddly for me.
    So this attitude keeps me away from finding it out myself by working up the learning curve for MS robotics studio.
    But if you can answers this easily because you are experienced with MS RS I'm interested in knowing it.

    best regards
    Stefan
  • Mike GMike G Posts: 2,702
    edited 2012-09-30 09:03
    Microsoft Robotics Studio is a .NET template for creating disconnected asynchronous services. To turn right MSRS sends the "turn right" command. The interpretation (protocol) of turn right is determined by the developer and defined by the uController firmware. MSRS can also receive information from a robot. Services listen for incoming data. The outcome is - again - up to the developer to define.

    Examples are openly published on MSRS
Sign In or Register to comment.