Fabricating Prototyping Board for Propeller Board

fatdawg1

Someone recently purchased the 40000-RT Propeller Kit from Radio Shack and gave it to me as a present. In watching the short film on the resource page, I noticed that the board had been modified to accept a prototyping board. I could not find a completed version of the board on the Parallax website. Anybody know how it was created? Thanks.

Duane Degn

If you mean the QuickStart with a breadboard attached, I think they just added one section of this breadboard to the back of the QuickStart.

Here's a link of some forum posts about the QuickStart.

Gadget Gangster sells the QuickStart with an additional PCB to make adding sensors and components easier. See post #1 of my index for a link to the GG deal (see my signature for my index).

Oldbitcollector (Jeff)

There is also this board: http://propellerpowered.com/shop/?page_id=643

Designed as a Universal Prototyping Board for the Quickstart. Recent project done with this board.

Jeff

cavelamb

Any Aurdino adapters out there?

Invent-O-Doc

See this forum - there is an arduino shield compatible propeller variant, though it is not made by parallax.

mindrobots

@cavelamb, an interesting design if I understand what you are asking for.

A board that will plug into the QuickStart 40 pin header and then provide an Arduino footprint (with analog pins and all) for stacking Arduino shields on top of a QuickStart. Could be fun if it could be made cost effective