Connecting motor driver board to propeller PCB

CharlieT

Hi,

I am following up on a previous post regarding operating a 12 V DC gearbox motor with propeller. After receiving some some helpful feedback, I decided to get the following motor driver board.

http://www.pololu.com/catalog/product/1212

I am a novice. Thus far, I have been able to build my project by following some of Gadget Gangster's step-by-step tutorials that are available online.

However, I am unsure of the correct way to wire/connect the motor driver board (see link above) to my project. Can someone advise me?

I am trying to connect the motor driver board to the breakout board (see below) that comes with the Gadget Gangster touchscreen module:

http://gadgetgangster.com/find-a-pro...projectnum=209

Any assistance would be greatly appreciated (and thanks again for all the help thus far).


Thanks,

Charlie