Altimeter Module MS5607

uosamor007

hi

i was just wondering if anyone had any code that allows me to get the temperature using this module. it would be much appreciated.
thanks

uosamor007

SPIN Code btw
thanks

Franklin

Have you looked here?http://www.parallax.com/Store/Sensors/AccelerationTilt/tabid/172/ProductID/780/List/0/Default.aspx?SortField=ProductName,ProductName

uosamor007

yes i have there is code for getting the pressure and the altitude but not the temperature

Phil Pilgrim (PhiPi)

Which driver are you using? The Spin driver, 29124_altimeter.spin, available at the link that Franklin posted, includes three methods for retrieving temperature, current_temp, median_temp, and average_temp.

-Phil

switchman

I am using a 29124 altimeter module and have difficulties. Pin SDO sends all ones and never goes to ground or battery. The spec sheet states that the max supply voltage as 4.0 V, so it is connected to 3 volts. Does the 4.0 V max refer to the little white object on the board or the board itself?

Genetix

This might help:

http://learn.parallax.com/KickStart/29124

switchman

Genetix wrote: »

This might help:

http://learn.parallax.com/KickStart/29124

Found problem, Stamp and module some distance apart, too much capacitance for SDO to drive. Now d2 and d1 are much too high. Have two modules, both agree that the temperature in my house is 150 degrees. Any ideas?