HELP! Interfacing PL7003 NTSC to Propeller Protoboard
nicole
Posts: 1
Hi! I'm a newbie learning about the propeller chip. I've been searching for hours and I can't seem to figure out how to interface the PL7003 A/V PAL NTSC to the protoboard. This was the board that came with the kit that Parallax sells, but no info is given as to how to connect it to the board. I know this seems like a really dumb question, but I would really appreciate it if someone could direct me to an interface pin-out. I don't know what I need to order/how to put everything together.
Thanks so much!!! > <
Thanks so much!!! > <
Comments
Use the circuit from this link on page 4.
http://dl.dropbox.com/u/7557533/ledgerlabs/Propeller%20Protoboard%20Designs%20for%20the%20Beginner.pdf
OBC