Help me: Using PropstickUSB with Memsic 2125 accelerometer

SteelHeart

Hi everyone, first off I'm sorry if i post at the wrong section.

Here's the thing, I'm building a UAV for a school project and I have zero programming knowledge.

Well, now I have the Parallax PropstickUSB with me and I have been trying to find information to get it working with the Memsic 2125 Accelerometer.
I have read about the sensor and it says to use the BASIC Stamp software. After researching for a bit, I find out that there are codes from the obex website, that I am able to use in the Spin software for propstickusb with the accelerometer, am i right?

If they can be use together, are there any schematics to wire them together?
Or atleast point to somewhere to start off with.

I have tried the connection myself (not sure if its right or wrong) with basic stamp and it wasn't able to find the hardware where as over at spin the propeller was identified.

Thanks in advance.

Franklin

On the page where Parallax sells the 2125 there are several tutorials, datasheets and links to all kinds of info. Go there and read some of that important info.
Yes it can be used with a propeller
The wiring diagram is on the pages referenced.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen