Shop OBEX P1 Docs P2 Docs Learn Events
Power Distribution Board — Parallax Forums

Power Distribution Board

NWCCTVNWCCTV Posts: 3,629
edited 2010-05-06 04:20 in General Discussion
Can anyone either post a schematic or point me to where I might find instructions to build a Power Distribution Board? I have 4 12V batteries that I would like to tie in to one location and distribute 5, 6, 9 and 12V DC through. Thanks if you can help.

Comments

  • Peter KG6LSEPeter KG6LSE Posts: 1,383
    edited 2010-05-06 02:20
    how much current per leg?


    Peter KG6LSE

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    "Carpe Ducktum" "seize the tape!!"
    peterthethinker.com/tesla/Venom/Venom.html
    Never underestimate the bandwidth of a station wagon full of tapes hurtling down the highway. —Tanenbaum, Andrew S.
    LOL
  • NWCCTVNWCCTV Posts: 3,629
    edited 2010-05-06 02:28
    This will vary depending on what is connected. I want to have various connections for each voltage. Current will range from 300 mA on the low end to approximately 3A on the high end. Make sense?
  • NWCCTVNWCCTV Posts: 3,629
    edited 2010-05-06 02:29
    Please note that not all legs for each voltage will be used at the same time. I may even build a couple boards to distribute the power.
  • SRLMSRLM Posts: 5,045
    edited 2010-05-06 04:20
    Hmmm. I have (had?) a thread with a very similar title... http://forums.parallax.com/showthread.php?p=799564

    Maybe you can get some ideas from it.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Powered by enthusiasm
Sign In or Register to comment.