Propeller USB Servo Controller and HiTec HMI
MitchT
Posts: 5
Is there any precedent for someone implementing HiTec's HMI servo protocol (in any form) with the Propeller Servo Controller board?
Other note - anyone have any experience "Disabling" a HiTec Digital servo using *any* form of HMI? There seems to be a "Stop" motor opcode but I havent been able to get it to do anything useful - I think it might just stop interpolation of whatever servo move command is currently in motion.
Read: "Looking for solution to turn off HiTec Digital Robotics servo via software rather than cutting power"
Read: "Looking for precedent of bidirectional HMI on propeller usb servo controller
Thanks for any info [noparse]:)[/noparse]
Other note - anyone have any experience "Disabling" a HiTec Digital servo using *any* form of HMI? There seems to be a "Stop" motor opcode but I havent been able to get it to do anything useful - I think it might just stop interpolation of whatever servo move command is currently in motion.
Read: "Looking for solution to turn off HiTec Digital Robotics servo via software rather than cutting power"
Read: "Looking for precedent of bidirectional HMI on propeller usb servo controller
Thanks for any info [noparse]:)[/noparse]