XBEE

RN

Hey i have just bought a stingray and doing small fun experiments in it. i interfaced sensors like PING , sound impact etc. now i want to do the wireless interfacing using XBEE. can anyone tell me where to connect those pins of XBEE. I know few of them but please help me out. I have done serial communication already

SRLM

Connect the VCC pin (1) to 3.3v, the gnd pin (10) to ground, the dout pin (2) to the Propeller RX pin, and the din pin (3) to the Propeller TX pin. That's all that you need for basic serial communications.

You may want to take a look at the free chapter of the new Propeller book. It's available in the Parallax webstore.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Powered by enthusiasm

SRLM

Also, please don't cross post. This is a propeller question, so it belongs in the Propeller forum. You delete your other message (assuming no replies) by clicking the red x on the post.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Powered by enthusiasm

Oldbitcollector (Jeff)

I'll second the chapter that is posted about the Xbees. Required reading.

Here's a quick link.

You should be able to get up and running easily enough using the connections that SRLM recommended.

OBC

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Are you Propeller Powered? PropellerPowered.com
Visit the: PROPELLERPOWERED SIG forum kindly hosted by Savage Circuits.

w8an

There's plenty of great documents at the Digi site as well.
Digi.com

-Steve

sylvie369

The documentation at the bottom of Martin Hebel's page is quite helpful as well:

http://selmaware.com/appbee/index.htm
·