Shop OBEX P1 Docs P2 Docs Learn Events
NEW: Propeller Platform SD - Limited quantities available now — Parallax Forums

NEW: Propeller Platform SD - Limited quantities available now

Nick McClickNick McClick Posts: 1,003
edited 2010-03-08 23:24 in Propeller 1
So, I made too many Rev. A prototypes - I have 12 extras. Instead of throwing them away, I thought I'd offer them at a discount for anyone who'd like them before the Rev. B boards are out.
4414557051_5e131f5292.jpg
Project Page

Specs
  • 2.8" x 2.5"
  • Compatible with all other Platform Modules (DMX IO, LCD UI, ProtoPlus, El Jugador, OctoDriver, PropNet, Prototyper, Tester, Battery, etc).
  • Pre-assembled and tested.
  • Includes 64k EEPROM, 5Mhz socketed crystal, and uSD card slot
  • Super low dropout regulators - they'll run within 100mV of the output voltage, so 5.1v input minimum.

They differ from Rev. B boards (which should be available early - mid April) in a few minor ways;
  • Aren't pre-programmed with a bootloader. You'll need a Prop Plug / Clip to program these
  • Don't have connections for screw terminal or RTC, although these can be added to a second module (like prototyper or ProtoPlus)
Otherwise, they'll be pretty much the same. Also, a few will have female pin sockets pre-attached, but most will have pin sockets included in the bag.

They're available for $30 right here. Let me know if you have any questions!


Update - here's a link to the schematic (diptrace) (pdf)

Nick

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Propeller Forums RSS Feed!

Gadget Gangster - Share your Electronic Projects

Post Edited (Nick McClick) : 3/8/2010 6:24:31 PM GMT

Comments

Sign In or Register to comment.