FT232RL issue
steprog
Posts: 227
Hello,
I found a mistake in my layout of the FTD device.· I discovered that I tied VCCIO to VCC instead of the 3.3VOut regulator on the device.· It sounds like that puts 5 volts on my rec and tx pins through resistors.· My communications have been good however but Im experiencing so IO pin issues and PASD doesn't load.· This could be unrelated but not sure.
I found a mistake in my layout of the FTD device.· I discovered that I tied VCCIO to VCC instead of the 3.3VOut regulator on the device.· It sounds like that puts 5 volts on my rec and tx pins through resistors.· My communications have been good however but Im experiencing so IO pin issues and PASD doesn't load.· This could be unrelated but not sure.